|
|
 |
350-401인증시험 - 350-401최신버전자료 & Implementing Cisco Enterprise Network Core Technologies 350-401 Encor - Royalholidayclubbed
|
|
RHC Destination Reviews
Who Is Harpy?
Need More Information?
경쟁이 치열한 IT업계에서 굳굳한 자신만의 자리를 찾으려면 국제적으로 인정받는 IT자격증 취득은 너무나도 필요합니다. Cisco인증 350-401인증시험시험은 IT인사들중에서 뜨거운 인기를 누리고 있습니다. Royalholidayclubbed는 IT인증시험에 대비한 시험전 공부자료를 제공해드리는 전문적인 사이트입니다.한방에 쉽게Cisco인증 350-401인증시험시험에서 고득점으로 패스하고 싶다면Royalholidayclubbed의Cisco인증 350-401인증시험덤프를 선택하세요.저렴한 가격에 비해 너무나도 높은 시험적중율과 시험패스율, 언제나 여러분을 위해 최선을 다하는Royalholidayclubbed가 되겠습니다. 우리 Royalholidayclubbed의 를Cisco 인증350-401인증시험 덤프공부자료를 선택해주신다면 우리는 최선을 다하여 여러분이 꼭 한번에 시험을 패스할 수 있도록 도와드리겠습니다.만약 여러분이 우리의 인증시험 덤프를 보시고 시험이랑 틀려서 패스를 하지 못하였다면 우리는 무조건 덤프비용 전부를 환불해드릴것입니다. Royalholidayclubbed제품으로 자격증을 정복합시다! Cisco인증 350-401인증시험시험은 IT인증시험중 가장 인기있는 국제승인 자격증을 취득하는데서의 필수시험과목입니다.그만큼 시험문제가 어려워 시험도전할 용기가 없다구요? 이제 이런 걱정은 버리셔도 됩니다.
Cisco 350-401인증시험 덤프는 모든 시험문제유형을 포함하고 있어 적중율이 아주 높습니다.
Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)인증시험 덤프정보 상세보기는 이 글의 링크를 클릭하시면 Royalholidayclubbed사이트에 들어오실수 있습니다. Royalholidayclubbed에는 전문적인 업계인사들이Cisco 350-401 자격증덤프시험문제와 답에 대하여 연구하여, 시험준비중인 여러분들한테 유용하고 필요한 시험가이드를 제공합니다. 만약Royalholidayclubbed의 제품을 구매하려면, 우리Royalholidayclubbed에서는 아주 디테일 한 설명과 최신버전 최고품질의자료를 즉적중율이 높은 문제와 답을제공합니다.Cisco 350-401 자격증덤프자료는 충분한 시험대비자료가 될 것입니다.
여러분이 우리Cisco 350-401인증시험문제와 답을 체험하는 동시에 우리Royalholidayclubbed를 선택여부에 대하여 답이 나올 것입니다. 우리는 백프로 여러분들한테 편리함과 통과 율은 보장 드립니다. 여러분이 안전하게Cisco 350-401인증시험시험을 패스할 수 있는 곳은 바로 Royalholidayclubbed입니다.
Cisco 350-401인증시험 - Royalholidayclubbed는 여러분의 연봉상승을 도와 드리겠습니다.
많은 시간과 돈이 필요 없습니다. 30분이란 특별학습가이드로 여러분은Cisco 350-401인증시험인증시험을 한번에 통과할 수 있습니다, Royalholidayclubbed에서Cisco 350-401인증시험시험자료의 문제와 답이 실제시험의 문제와 답과 아주 비슷한 덤프만 제공합니다.
자기한테 딱 맞는 시험준비공부자료 마련은 아주 중요한 것입니다. Royalholidayclubbed는 업계에 많이 알려져있는 덤프제공 사이트입니다.
350-401 PDF DEMO:
QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 5
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
Huawei H19-635_V1.0 - Royalholidayclubbed에서는 시험문제가 업데이트되면 덤프도 업데이트 진행하도록 최선을 다하여 업데이트서비스를 제공해드려 고객님께서소유하신 덤프가 시장에서 가장 최신버전덤프로 되도록 보장하여 시험을 맞이할수 있게 도와드립니다. EMC D-PVM-OE-01 - Royalholidayclubbed는 저희 제품을 구매한 분들이 100%통과율을 보장해드리도록 최선을 다하고 있습니다. Royalholidayclubbed의 Cisco ISTQB CTAL-TM-001-KR덤프가 고객님의 시험패스테 조금이나마 도움이 되신다면 행복으로 느끼겠습니다. ACAMS CAMS-CN - 이는Royalholidayclubbed 의 IT전문가가 오랜 시간동안 IT인증시험을 연구한 끝에 시험대비자료로 딱 좋은 덤프를 제작한 결과입니다. 네트웨크시대인 지금 인터넷에 검색하면 수많은Cisco인증 Cisco 100-140시험공부자료가 검색되는데 그중에서도Royalholidayclubbed에서 출시한 Cisco인증 Cisco 100-140덤프가 가장 높은 인지도를 지니고 있습니다.
Updated: May 28, 2022
|
Copyright © 2006-2007 by RHC.
All rights
reserved. |
---------------
If you don't find what you are looking for here
to help you resolve your timeshare scam or Royal Holiday problem
please write to us at:
harpy @ royalholidayclubbed.com
www . Royal Holiday Clubbed . com
|
|