|
|
 |
350-401最新対策問題 & 350-401学習範囲、350-401赤本勉強 - Royalholidayclubbed
|
|
RHC Destination Reviews
Who Is Harpy?
Need More Information?
Royalholidayclubbedの専門家チームがCiscoの350-401最新対策問題認証試験に対して最新の短期有効なトレーニングプログラムを研究しました。Ciscoの350-401最新対策問題「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に参加者に対して30時間ぐらいの短期の育成訓練でらくらくに勉強しているうちに多くの知識を身につけられます。 我々IT専門かたちの作成するCiscoの350-401最新対策問題ソフトを利用しているとき、あなたは自分の能力の高めを明らかに感じることができます。Ciscoの350-401最新対策問題試験は常に更新されていますから、あなたに一番新しい資料を提供するために、我々はご購入の後で一年間の無料更新サービスを提供してあなたに安心させます。 きっと君に失望させないと信じています。
CCNP Enterprise 350-401 素晴らしい試験参考書です。
IT認定試験の中でどんな試験を受けても、Royalholidayclubbedの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)最新対策問題試験参考資料はあなたに大きなヘルプを与えることができます。 弊社は強力な教師チームがあって、彼たちは正確ではやくて例年のCisco 350-401 無料過去問認定試験の資料を整理して、直ちにもっとも最新の資料を集めて、弊社は全会一緻で認められています。Cisco 350-401 無料過去問試験認証に合格確率はとても小さいですが、Royalholidayclubbedはその合格確率を高めることが信じてくだい。
その中で、350-401最新対策問題認定試験は最も重要な一つです。では、この試験に合格するためにどのように試験の準備をしているのですか。がむしゃらに試験に関連する知識を勉強しているのですか。
Cisco 350-401最新対策問題 - 早速買いに行きましょう。
Royalholidayclubbedのシニア専門家チームはCiscoの350-401最新対策問題試験に対してトレーニング教材を研究できました。Royalholidayclubbedが提供した教材を勉強ツルとしてCiscoの350-401最新対策問題認定試験に合格するのはとても簡単です。Royalholidayclubbedも君の１００％合格率を保証いたします。
それは正確性が高くて、カバー率も広いです。あなたはRoyalholidayclubbedの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。
350-401 PDF DEMO:
QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
CompTIA CS0-003 - Royalholidayclubbedにその問題が心配でなく、わずか20時間と少ないお金をを使って楽に試験に合格することができます。 もちろん、我々はあなたに一番安心させるのは我々の開発する多くの受験生に合格させるCiscoのISTQB CTAL-TM-001-KR試験のソフトウェアです。 Microsoft DP-100J - Royalholidayclubbedはたくさんの方がIT者になる夢を実現させるサイトでございます。 CiscoのSAP C-S4CPR-2502の購入の前にあなたの無料の試しから、購入の後での一年間の無料更新まで我々はあなたのCiscoのSAP C-S4CPR-2502試験に一番信頼できるヘルプを提供します。 NICET ITFAS-Level-1 - Royalholidayclubbedを選択したら、成功をとりましょう。
Updated: May 28, 2022
|
Copyright © 2006-2007 by RHC.
All rights
reserved. |
---------------
If you don't find what you are looking for here
to help you resolve your timeshare scam or Royal Holiday problem
please write to us at:
harpy @ royalholidayclubbed.com
www . Royal Holiday Clubbed . com
|
|