Home
My
$18,000 Timeshare Story
Objectives
The
Power Of Two
Other
People's Stories
Important
Links
Timeshare
Articles
RHC
Destination Reviews
Who
Is Harpy?
Write
To Harpy
Throw
Harpy A Fish!
The
Timeshare Club
Bookmark
this site
Need
More Information?
|
IT業種を選んだ私は自分の実力を証明したのです。しかし、神様はずっと私を向上させることを要求します。Ciscoの350-401受験記試験を受けることは私の人生の挑戦の一つです。 Royalholidayclubbedを選んだら、あなたは簡単に認定試験に合格することができますし、あなたはITエリートたちの一人になることもできます。まだ何を待っていますか。 これは間違いなくあなたが一番信頼できる350-401受験記試験に関連する資料です。
CCNP Enterprise 350-401 IT認定試験を受験するのは一つの良い方法です。Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)受験記試験に失敗しても、我々はあなたの経済損失を減少するために全額で返金します。 もし不合格になったら、私たちは全額返金することを保証します。一回だけでCiscoの350-401 合格体験記試験に合格したい?Royalholidayclubbedは君の欲求を満たすために存在するのです。
自分の能力を証明するために、350-401受験記試験に合格するのは不可欠なことです。弊社の350-401受験記真題を入手して、試験に合格する可能性が大きくなります。社会と経済の発展につれて、多くの人はIT技術を勉強します。
Cisco 350-401受験記 - 最もよくて最新で資料を提供いたします。あなたにCiscoの350-401受験記試験に合格できるのは我々の努力への最大の認可です。この目標を達成するために、我々はCiscoの350-401受験記試験の資料を改善し続けてあなたに安心に利用させます。我々の商品とサービスに疑問があったら、我々Royalholidayclubbedのウェブ・サイトで問い合わせたり、メールで我々と連絡したりすることができます。あなたの購入してから、Ciscoの350-401受験記試験ソフトが更新されたら、我々はメールであなたを通知します。
Cisco 350-401受験記「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に合格することが簡単ではなくて、Cisco 350-401受験記証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。
350-401 PDF DEMO:QUESTION NO: 1 Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are mode, the port channel does not establish. Based on the configuration excerpt of SW3, what is the cause of the problem? A. The port-channel interface lead balance should be set to src-mac B. The port-channel trunk is not allowing the native VLAN. C. The port-channel should be set to auto. D. The port channel on SW2 is using an incompatible protocol. Answer: D Explanation: The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2 Which statement about multicast RPs is true? A. RPs are required for protocol independent multicast sparse mode and dense mode. B. By default, the RP is needed only to start new sessions with sources and receivers. C. By default, the RP is needed periodically to maintain sessions with sources and receivers D. RPs are required only when using protocol independent multicast dense mode. Answer: B Explanation: A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM). By default, the RP is needed only to start new sessions with sources and receivers. Reference: https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3 Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model? A. IPsec B. Cisco Trustsec C. MACsec D. SSL Answer: C Explanation: MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of -band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre Shared Key (PSK) framework. A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a MKA peer) using the current session key. Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16- 9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4 To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller. Which EtherChannel mode must be configured on the switch to allow the WLC to connect? A. Active B. On C. Auto D. Passive Answer: B Explanation: Restrictions for Link Aggregation: You can bundle all eight ports on a Cisco 5508 Controller into a single link. Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group. LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch. Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller. If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller. https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5 Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80? A. Deny tcp any any ne 80 Permit tcp any any range 22 443 B. Permit tcp any any ne 80 C. Permit tco any any range 22 443 Deny tcp any any eq 80 D. Deny tcp any any eq 80 Permit tco any any gt 21 it 444 Answer: D
Microsoft DP-600J問題集を手に入れる前のサービスであれば、アフタサービスであれば、弊社はお客様の皆様の認めを得られるために、皆様の質問をすぐに返答できて準備しています。 PECB ISO-IEC-42001-Lead-Auditor - 今の社会の中で、ネット上で訓練は普及して、弊社は試験問題集を提供する多くのネットの一つでございます。 弊社のCiscoのEMC D-CIS-FN-01練習問題を利用したら、あなたは気楽に勉強するだけではなく、順調に試験に合格します。 Royalholidayclubbedは実際の環境で本格的なCiscoのAmazon MLS-C01「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」の試験の準備過程を提供しています。 受験生としてのあなたはCisco Microsoft MS-102-KR試験に関する高い質量の資料を提供します。
Updated: May 28, 2022
|
|