350-401참고자료 - 350-401 Dumps & Implementing Cisco Enterprise Network Core Technologies 350-401 Encor - Royalholidayclubbed

RHC Destination Reviews

Who Is Harpy?

Need More Information?

우선 우리Royalholidayclubbed 사이트에서Cisco 350-401참고자료관련자료의 일부 문제와 답 등 샘플을 제공함으로 여러분은 무료로 다운받아 체험해보실 수 있습니다.체험 후 우리의Royalholidayclubbed에 신뢰감을 느끼게 됩니다. Royalholidayclubbed에서 제공하는Cisco 350-401참고자료덤프로 시험 준비하시면 편안하게 시험을 패스하실 수 있습니다. 하지만Cisco인증 350-401참고자료시험패스는 하늘에 별따기 만큼 어렵습니다. 시험이 영어로 출제되어 공부자료 마련도 좀 힘든편입니다. 시험적중율 최고에 많은 공부가 되었다고 희소식을 전해올때마다 Royalholidayclubbed는 더욱 완벽한Cisco인증350-401참고자료시험덤프공부자료로 수정하고기 위해 최선을 다해왔습니다.

CCNP Enterprise 350-401 두 버전을 모두 구입하시면 시험에서 고득점으로 패스가능합니다.

Royalholidayclubbed의 Cisco인증 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)참고자료덤프를 구매하시고 공부하시면 밝은 미래를 예약한것과 같습니다. Royalholidayclubbed의Cisco인증 350-401 시험덤프공부시험대비 덤프는 가격이 착한데 비하면 품질이 너무 좋은 시험전 공부자료입니다. 시험문제적중율이 높아 패스율이 100%에 이르고 있습니다.다른 IT자격증에 관심이 있는 분들은 온라인서비스에 문의하여 덤프유무와 적중율등을 확인할수 있습니다.

Cisco인증 350-401참고자료덤프로Cisco인증 350-401참고자료시험을 준비하여 한방에 시험패스한 분이 너무나도 많습니다. Cisco인증 350-401참고자료덤프는 실제Cisco인증 350-401참고자료시험문제에 초점을 맞추어 제작한 최신버전 덤프로서 시험패스율이 100%에 달합니다. Royalholidayclubbed의Cisco인증 350-401참고자료 덤프는 수많은 시험준비 공부자료 중 가장 믿음직합니다.

Cisco 350-401참고자료 - 시험에서 떨어지면 덤프비용전액환불해드립니다.

Cisco인증 350-401참고자료시험에 도전하고 싶으시다면 최강 시험패스율로 유명한Royalholidayclubbed의 Cisco인증 350-401참고자료덤프로 시험공부를 해보세요. 시간절약은 물론이고 가격도 착해서 간단한 시험패스에 딱 좋은 선택입니다. Cisco 인증350-401참고자료시험출제경향을 퍼펙트하게 연구하여Royalholidayclubbed에서는Cisco 인증350-401참고자료시험대비덤프를 출시하였습니다. Royalholidayclubbed제품은 고객님의 IT자격증 취득의 앞길을 훤히 비추어드립니다.

Cisco 350-401참고자료덤프자료를 항상 최신버전으로 보장해드리기 위해Cisco 350-401참고자료시험문제가 변경되면 덤프자료를 업데이트하도록 최선을 다하고 있습니다. Royalholidayclubbed는 여러분이 자격증을 취득하는 길에서 없어서는 안되는 동반자로 되어드릴것을 약속해드립니다.

350-401 PDF DEMO:

QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

Cisco Adobe AD0-E605 덤프로Cisco Adobe AD0-E605시험을 패스하여 자격즉을 쉽게 취득해보지 않으실래요? 마술처럼Cisco Juniper JN0-481시험합격이 실현될것입니다. Cisco Huawei H20-723_V1.0 시험을 합격하여 자격증을 손에 넣는다면 취직 혹은 연봉인상 혹은 승진이나 이직에 확실한 가산점이 될것입니다. 이는 응시자가 확실하고도 빠르게Cisco SAP C-SIGDA-2403덤프를 마스터하고Cisco SAP C-SIGDA-2403시험을 패스할수 있도록 하는 또 하나의 보장입니다. Pass4Tes의Cisco CompTIA CNX-001합습가이드는 시험의 예상문제부터 전면적이로 만들어진 아주 퍼펙트한 시험자료입니다.

Updated: May 28, 2022

by RHC.

---------------

If you don't find what you are looking for here

to help you resolve your timeshare scam or Royal Holiday problem

please write to us at:

harpy @ royalholidayclubbed.com

Link Partner Directory

www . Royal Holiday Clubbed . com

sitemap