|
|
 |
200-301인증시험덤프 - Cisco Certified Network Associate Exam시험정보 - Royalholidayclubbed
|
|
RHC Destination Reviews
Who Is Harpy?
Need More Information?
Royalholidayclubbed제품에 대하여 아주 자신이 있습니다. Cisco 인증200-301인증시험덤프 도 여러분의 무용지물이 아닌 아주 중요한 자료가 되리라 믿습니다. 여러분께서는 아주 순조로이 시험을 패스하실 수 있을 것입니다. Royalholidayclubbed의 Cisco 200-301인증시험덤프덤프를 공부하면 100% Cisco 200-301인증시험덤프 시험패스를 보장해드립니다. 만약 Cisco 200-301인증시험덤프 덤프자료를 구매하여 공부한후 시험에 탈락할시 불합격성적표와 주문번호를 메일로 보내오시면 덤프비용을 바로 환불해드립니다. Cisco 200-301인증시험덤프덤프는 IT 업계 종사자들에 있어서 아주 중요한 인증시험이자 인기 자격증을 취득할수 있는 필수과목입니다.
Cisco 200-301인증시험덤프인증은 아주 중요한 인증시험중의 하나입니다.
Royalholidayclubbed에서Cisco 200-301 - Cisco Certified Network Associate Exam인증시험덤프시험덤프를 구입하시면 퍼펙트한 구매후 서비스를 제공해드립니다. 그리고 우리는 덤프를 구매 시 일년무료 업뎃을 제공합니다. 여러분은 먼저 우리 Royalholidayclubbed사이트에서 제공되는Cisco인증200-301 테스트자료시험덤프의 일부분인 데모 즉 문제와 답을 다운받으셔서 체험해보실 수 잇습니다.
Cisco 200-301인증시험덤프 덤프결제에 관하여 불안정하게 생각되신다면 paypal에 대해 알아보시면 믿음이 생길것입니다. 더욱 안전한 지불을 위해 저희 사이트의 모든 덤프는paypal을 통해 지불을 완성하게 되어있습니다. Paypal을 거쳐서 지불하면 저희측에서Cisco 200-301인증시험덤프덤프를 보내드리지 않을시 paypal에 환불신청하실수 있습니다.
Cisco인증Cisco 200-301인증시험덤프시험패는Royalholidayclubbed제품으로 고고고!
Royalholidayclubbed 는 여러분의 it전문가 꿈을 이루어드리는 사이트 입다. Royalholidayclubbed는 여러분이 우리 자료로 관심 가는 인중시험에 응시하여 안전하게 자격증을 취득할 수 있도록 도와드립니다. 아직도Cisco 200-301인증시험덤프인증시험으로 고민하시고 계십니까? Cisco 200-301인증시험덤프인증시험가이드를 사용하실 생각은 없나요? Royalholidayclubbed는 여러분에 편리를 드릴 수 잇습니다. Royalholidayclubbed의 자료는 시험대비최고의 덤프로 시험패스는 문제없습니다. Royalholidayclubbed의 각종인증시험자료는 모두기출문제와 같은 것으로 덤프보고 시험패스는 문제없습니다. Royalholidayclubbed의 퍼펙트한 덤프인 M crosoft200-301인증시험덤프인증시험자료의 문제와 답만 열심히 공부하면 여러분은 완전 안전히Cisco 200-301인증시험덤프인증자격증을 취득하실 수 있습니다.
거침없이 발전해나가는 IT업계에서 자신만의 자리를 동요하지 않고 단단히 지킬려면Cisco인증 200-301인증시험덤프시험은 무조건 패스해야 합니다. 하지만Cisco인증 200-301인증시험덤프시험패스는 하늘에 별따기 만큼 어렵습니다.
200-301 PDF DEMO:
QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 2
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 3
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 4
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
QUESTION NO: 5
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
여러분은 먼저 우리 Royalholidayclubbed사이트에서 제공되는Cisco인증Adobe AD0-E907시험덤프의 일부분인 데모 즉 문제와 답을 다운받으셔서 체험해보실 수 잇습니다. Salesforce PDI - 성공을 위해 길을 찾고 실패를 위해 구실을 찾지 않는다는 말이 있습니다. Royalholidayclubbed는 여러분이Cisco Palo Alto Networks PCNSE인증시험을 통과할 수 잇도록 도와주는 사이트입니다. Cisco인증 Microsoft DP-203-KR덤프뿐만아니라 IT인증시험에 관한 모든 덤프를 제공해드립니다. Cisco 350-701 - Royalholidayclubbed에서는 소프트웨어버전과 PDF버전 두가지버전으로 덤프를 제공해드립니다.PDF버전은 구매사이트에서 무료샘플을 다움받아 체험가능합니다.
Updated: May 28, 2022
|
Copyright © 2006-2007 by RHC.
All rights
reserved. |
---------------
If you don't find what you are looking for here
to help you resolve your timeshare scam or Royal Holiday problem
please write to us at:
harpy @ royalholidayclubbed.com
www . Royal Holiday Clubbed . com
|
|