|
|
 |
350-401 Dumps Cost - Cisco Valid Braindumps Implementing Cisco Enterprise Network Core Technologies 350-401 Encor Book - Royalholidayclubbed
|
|
RHC Destination Reviews
Who Is Harpy?
Need More Information?
It’s our responsibility to offer instant help to every user on our 350-401 Dumps Cost exam questions. If you have any question about 350-401 Dumps Cost study materials, please do not hesitate to leave us a message or send us an email. Our customer service staff will be delighted to answer your questions on the 350-401 Dumps Cost learing engine. As a result, many customers get manifest improvement and lighten their load by using our 350-401 Dumps Cost actual exam. It is well-known that our 350-401 Dumps Cost study guide can save a lot of time and effort. The prices of the 350-401 Dumps Cost exam questions are reasonable and affordable while the quality of them are unmatched high.
CCNP Enterprise 350-401 Good chances are few.
CCNP Enterprise 350-401 Dumps Cost - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Remember this version support Windows system users only. Whenever it is possible, you can begin your study as long as there has a computer. In addition, all installed New 350-401 Exam Format study tool can be used normally.
Get the test 350-401 Dumps Cost certification is not achieved overnight, we need to invest a lot of time and energy to review, and the review process is less a week or two, more than a month or two, or even half a year, so 350-401 Dumps Cost exam questions are one of the biggest advantage is that it is the most effective tools for saving time for users. Users do not need to spend too much time on 350-401 Dumps Cost questions torrent, only need to use their time pieces for efficient learning, the cost is about 20 to 30 hours, users can easily master the test key and difficulties of questions and answers of 350-401 Dumps Cost prep guide, and in such a short time acquisition of accurate examination skills, better answer out of step, so as to realize high pass the qualification test, has obtained the corresponding qualification certificate.
Cisco 350-401 Dumps Cost - Also, the system will deduct the relevant money.
We all know that 350-401 Dumps Cost learning guide can help us solve learning problems. But if it is too complex, not only can’t we get good results, but also the burden of students' learning process will increase largely. Unlike those complex and esoteric materials, our 350-401 Dumps Cost preparation prep is not only of high quality, but also easy to learn. For our professional experts simplified the content of the350-401 Dumps Cost exam questions for all our customers to be understood.
In order to remain competitive in the market, our company has been keeping researching and developing of the new 350-401 Dumps Cost exam questions. We are focused on offering the most comprehensive 350-401 Dumps Cost study materials which cover all official tests.
350-401 PDF DEMO:
QUESTION NO: 1
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 2
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html
QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
Some candidates may like to accept the help of their friends or mentors, and some candidates may only rely on some PRAXIS Business-Education-Content-Knowledge-5101 books. Network Appliance NS0-901 - Then sooner or later you will be promoted by your boss. Every day of our daily life seems to be the same rhythm, work to eat and sleep, and all the daily arrangements, the exam does not go through every day, especially for the key ISTQB CTAL-TM-001-KR qualification test ready to be more common. We have left some space for you to make notes on the PDF version of the SAP C-THR81-2411 study materials. NAHQ CPHQ - Believe that there is such a powerful expert help, our users will be able to successfully pass the qualification test to obtain the qualification certificate.
Updated: May 28, 2022
|
Copyright © 2006-2007 by RHC.
All rights
reserved. |
---------------
If you don't find what you are looking for here
to help you resolve your timeshare scam or Royal Holiday problem
please write to us at:
harpy @ royalholidayclubbed.com
www . Royal Holiday Clubbed . com
|
|