|
|
 |
350-401認定試験トレーリング & 350-401試験資料 - 350-401的中合格問題集 - Royalholidayclubbed
|
|
RHC Destination Reviews
Who Is Harpy?
Need More Information?
Ciscoの認証資格は最近ますます人気になっていますね。国際的に認可された資格として、Ciscoの認定試験を受ける人も多くなっています。その中で、350-401認定試験トレーリング認定試験は最も重要な一つです。 ご安心で試験のために勉強します。Ciscoの350-401認定試験トレーリング試験の準備に悩んでいますか。 早速買いに行きましょう。
CCNP Enterprise 350-401 それは正確性が高くて、カバー率も広いです。
これらをするのはあなたのCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)認定試験トレーリング試験を準備する圧力を減少するためです。 我々はあなたに提供するのは最新で一番全面的なCiscoの350-401 テストトレーニング問題集で、最も安全な購入保障で、最もタイムリーなCiscoの350-401 テストトレーニング試験のソフトウェアの更新です。無料デモはあなたに安心で購入して、購入した後1年間の無料Ciscoの350-401 テストトレーニング試験の更新はあなたに安心で試験を準備することができます、あなたは確実に購入を休ませることができます私たちのソフトウェアを試してみてください。
お客様は自分に相応しい350-401認定試験トレーリング問題集のバージョンを選ぶことができます。弊社は「ご客様の満足度は私達のサービス基準である」の原則によって、いつまでもご客様に行き届いたサービスを提供できて喜んでいます。弊社の350-401認定試験トレーリング問題集は三種類の版を提供いたします。
Cisco 350-401認定試験トレーリング - こうして、君は安心で試験の準備を行ってください。
350-401認定試験トレーリング試験はCiscoの認定試験の一つですが、もっとも重要なひとつです。Ciscoの350-401認定試験トレーリングの認定試験に合格するのは簡単ではなくて、Royalholidayclubbedは350-401認定試験トレーリング試験の受験生がストレスを軽減し、エネルギーと時間を節約するために専門研究手段として多様な訓練を開発して、Royalholidayclubbedから君に合ったツールを選択してください。
Cisco 350-401認定試験トレーリング「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に合格することが簡単ではなくて、Cisco 350-401認定試験トレーリング証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。
350-401 PDF DEMO:
QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
Microsoft MS-102-KR試験はCiscoの一つ重要な認証試験で多くのIT専門スタッフが認証される重要な試験です。 HP HPE7-A08 - 今の社会の中で、ネット上で訓練は普及して、弊社は試験問題集を提供する多くのネットの一つでございます。 Oracle 1z0-1196-25 - 成功を祈ります。 SAP C-S4CPB-2502 - 試験問題と解答に関する質問があるなら、当社は直後に解決方法を差し上げます。 CiscoのGitHub GitHub-Advanced-Security認定試験「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」によい準備ができて、試験に穏やかな心情をもって扱うことができます。
Updated: May 28, 2022
|
Copyright © 2006-2007 by RHC.
All rights
reserved. |
---------------
If you don't find what you are looking for here
to help you resolve your timeshare scam or Royal Holiday problem
please write to us at:
harpy @ royalholidayclubbed.com
www . Royal Holiday Clubbed . com
|
|