Home
My
$18,000 Timeshare Story
Objectives
The
Power Of Two
Other
People's Stories
Important
Links
Timeshare
Articles
RHC
Destination Reviews
Who
Is Harpy?
Write
To Harpy
Throw
Harpy A Fish!
The
Timeshare Club
Bookmark
this site
Need
More Information?
|
RoyalholidayclubbedのCiscoの350-401無料模擬試験問題集を購入したら、私たちは君のために、一年間無料で更新サービスを提供することができます。もし不合格になったら、私たちは全額返金することを保証します。一回だけでCiscoの350-401無料模擬試験試験に合格したい?Royalholidayclubbedは君の欲求を満たすために存在するのです。 そうすると人生には意義があります。人生のチャンスを掴むことができる人は殆ど成功している人です。 うちのCiscoの350-401無料模擬試験試験トレーニング資料を購入する前に、Royalholidayclubbedのサイトで、一部分のフリーな試験問題と解答をダンロードでき、試用してみます。
CCNP Enterprise 350-401 我々の誠意を信じてください。CCNP Enterprise 350-401無料模擬試験 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) それはIT専門家達は出題のポイントをよく掴むことができて、実際試験に出題される可能性があるすべての問題を問題集に含めることができますから。 自分のIT業界での発展を希望したら、Ciscoの350-401 模擬試験問題集試験に合格する必要があります。Ciscoの350-401 模擬試験問題集試験はいくつ難しくても文句を言わないで、我々Royalholidayclubbedの提供する資料を通して、あなたはCiscoの350-401 模擬試験問題集試験に合格することができます。
もし受験したいなら、試験の準備をどのようにするつもりですか。もしかして、自分に相応しい試験参考書を見つけたのでしょうか。では、どんな参考書は選べる価値を持っていますか。
Cisco 350-401無料模擬試験 - 弊社の商品はあなたの圧力を減少できます。あなたは350-401無料模擬試験試験に不安を持っていますか?350-401無料模擬試験参考資料をご覧下さい。私たちの350-401無料模擬試験参考資料は十年以上にわたり、専門家が何度も練習して、作られました。あなたに高品質で、全面的な350-401無料模擬試験参考資料を提供することは私たちの責任です。私たちより、350-401無料模擬試験試験を知る人はいません。
だから、こんなに保障がある復習ソフトはあなたにCiscoの350-401無料模擬試験試験を心配させていません。我々RoyalholidayclubbedのCiscoの350-401無料模擬試験試験のソフトウェアを使用し、あなたはCiscoの350-401無料模擬試験試験に合格することができます。
350-401 PDF DEMO:QUESTION NO: 1 Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are mode, the port channel does not establish. Based on the configuration excerpt of SW3, what is the cause of the problem? A. The port-channel interface lead balance should be set to src-mac B. The port-channel trunk is not allowing the native VLAN. C. The port-channel should be set to auto. D. The port channel on SW2 is using an incompatible protocol. Answer: D Explanation: The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2 Which statement about multicast RPs is true? A. RPs are required for protocol independent multicast sparse mode and dense mode. B. By default, the RP is needed only to start new sessions with sources and receivers. C. By default, the RP is needed periodically to maintain sessions with sources and receivers D. RPs are required only when using protocol independent multicast dense mode. Answer: B Explanation: A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM). By default, the RP is needed only to start new sessions with sources and receivers. Reference: https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3 Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model? A. IPsec B. Cisco Trustsec C. MACsec D. SSL Answer: C Explanation: MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of -band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre Shared Key (PSK) framework. A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a MKA peer) using the current session key. Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16- 9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4 Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80? A. Deny tcp any any ne 80 Permit tcp any any range 22 443 B. Permit tcp any any ne 80 C. Permit tco any any range 22 443 Deny tcp any any eq 80 D. Deny tcp any any eq 80 Permit tco any any gt 21 it 444 Answer: D
QUESTION NO: 5 To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller. Which EtherChannel mode must be configured on the switch to allow the WLC to connect? A. Active B. On C. Auto D. Passive Answer: B Explanation: Restrictions for Link Aggregation: You can bundle all eight ports on a Cisco 5508 Controller into a single link. Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group. LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch. Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller. If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller. https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
Royalholidayclubbedは専門のIT業界での評判が高くて、あなたがインターネットでRoyalholidayclubbedの部分のCisco Microsoft SC-200J「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」資料を無料でダウンロードして、弊社の正確率を確認してください。 我々実力が強いITチームの提供するCiscoのMicrosoft MB-700ソフトはあなたに満足させることができます。 SAP C_TS422_2023-JPN - Royalholidayclubbed を選択して100%の合格率を確保することができて、もし試験に失敗したら、Royalholidayclubbedが全額で返金いたします。 弊社のAmazon SAP-C02問題集はあなたにこのチャンスを全面的に与えられます。 GitHub GitHub-Advanced-Security - 早くRoyalholidayclubbedの問題集を君の手に入れましょう。
Updated: May 28, 2022
|
|