|
|
 |
350-401日本語版復習指南、350-401ダウンロード - Cisco 350-401受験料過去問 - Royalholidayclubbed
|
|
RHC Destination Reviews
Who Is Harpy?
Need More Information?
RoyalholidayclubbedのCiscoの350-401日本語版復習指南試験トレーニング資料はインターネットでの全てのトレーニング資料のリーダーです。Royalholidayclubbedはあなたが首尾よく試験に合格することを助けるだけでなく、あなたの知識と技能を向上させることもできます。あなたが自分のキャリアでの異なる条件で自身の利点を発揮することを助けられます。 IT業界で働いている多くの人はCiscoの350-401日本語版復習指南試験の準備が大変だと知っています。我々Royalholidayclubbedは350-401日本語版復習指南試験の難しさを減らないとは言え、試験準備の難しさを減ることができます。 また、RoyalholidayclubbedのCiscoの350-401日本語版復習指南試験トレーニング資料が信頼できるのは多くの受験生に証明されたものです。
その中で、350-401日本語版復習指南認定試験は最も重要な一つです。
CCNP Enterprise 350-401日本語版復習指南 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) もし運が良くないとき、失敗したら、お金を返してあなたの経済損失を減らします。 RoyalholidayclubbedのCiscoの350-401 試験勉強過去問試験トレーニング資料を使ったら、君のCiscoの350-401 試験勉強過去問認定試験に合格するという夢が叶えます。なぜなら、それはCiscoの350-401 試験勉強過去問認定試験に関する必要なものを含まれるからです。
Cisco 350-401日本語版復習指南資格認定はバッジのような存在で、あなたの所有する専業技術と能力を上司に直ちに知られさせます。次のジョブプロモーション、プロジェクタとチャンスを申し込むとき、Cisco 350-401日本語版復習指南資格認定はライバルに先立つのを助け、あなたの大業を成し遂げられます。
Cisco 350-401日本語版復習指南 - それは正確性が高くて、カバー率も広いです。
あなたは今やはり350-401日本語版復習指南試験に悩まされていますか？長い時間350-401日本語版復習指南試験を取り組んいる弊社はあなたに350-401日本語版復習指南練習問題を提供できます。あなたは350-401日本語版復習指南試験に興味を持たれば、今から行動し、350-401日本語版復習指南練習問題を買いましょう。350-401日本語版復習指南試験に合格するために、350-401日本語版復習指南練習問題をよく勉強すれば、いい成績を取ることが難しいことではありません。つまり350-401日本語版復習指南練習問題はあなたの最も正しい選択です。
もちろん、我々はあなたに一番安心させるのは我々の開発する多くの受験生に合格させるCiscoの350-401日本語版復習指南試験のソフトウェアです。我々はあなたに提供するのは最新で一番全面的なCiscoの350-401日本語版復習指南問題集で、最も安全な購入保障で、最もタイムリーなCiscoの350-401日本語版復習指南試験のソフトウェアの更新です。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
先月、Apple DEP-2025-JPN試験に参加しました。 CiscoのNAHQ CPHQの購入の前にあなたの無料の試しから、購入の後での一年間の無料更新まで我々はあなたのCiscoのNAHQ CPHQ試験に一番信頼できるヘルプを提供します。 あなたはその他のCisco VMware 3V0-41.22「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に関するツールサイトでも見るかも知れませんが、弊社はIT業界の中で重要な地位があって、Royalholidayclubbedの問題集は君に100%で合格させることと君のキャリアに変らせることだけでなく一年間中で無料でサービスを提供することもできます。 Fortinet NSE5_FSM-6.3 - 社会と経済の発展につれて、多くの人はIT技術を勉強します。 Royalholidayclubbedを通じて最新のCiscoのISACA CRISC試験の問題と解答早めにを持てて、弊社の問題集があればきっと君の強い力になります。
Updated: May 28, 2022
|
Copyright © 2006-2007 by RHC.
All rights
reserved. |
---------------
If you don't find what you are looking for here
to help you resolve your timeshare scam or Royal Holiday problem
please write to us at:
harpy @ royalholidayclubbed.com
www . Royal Holiday Clubbed . com
|
|