Home
My
$18,000 Timeshare Story
Objectives
The
Power Of Two
Other
People's Stories
Important
Links
Timeshare
Articles
RHC
Destination Reviews
Who
Is Harpy?
Write
To Harpy
Throw
Harpy A Fish!
The
Timeshare Club
Bookmark
this site
Need
More Information?
|
多くの受験生は我々のソフトでCiscoの350-401日本語版トレーリング試験に合格したので、我々は自信を持って我々のソフトを利用してあなたはCiscoの350-401日本語版トレーリング試験に合格する保障があります。IT業界の発展とともに、IT業界で働いている人への要求がますます高くなります。競争の中で排除されないように、あなたはCiscoの350-401日本語版トレーリング試験に合格しなければなりません。 Ciscoの350-401日本語版トレーリング試験に合格することは容易なことではなくて、良い訓練ツールは成功の保証でRoyalholidayclubbedは君の試験の問題を準備してしまいました。君の初めての合格を目標にします。 異なるバーションはあなたに違う体験を感じさせます。
CCNP Enterprise 350-401 どんな困難にあっても、諦めないです。CCNP Enterprise 350-401日本語版トレーリング - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) IT認証は同業種の欠くことができないものになりました。 そのデモは350-401 問題集無料試験資料の一部を含めています。私たちは本当にお客様の貴重な意見を350-401 問題集無料試験資料の作りの考慮に入れます。
Royalholidayclubbedに会ったら、最高のトレーニング資料を見つけました。RoyalholidayclubbedのCiscoの350-401日本語版トレーリング試験トレーニング資料を持っていたら、試験に対する充分の準備がありますから、安心に利用したください。Royalholidayclubbedは優れたIT情報のソースを提供するサイトです。
Cisco 350-401日本語版トレーリング認定試験に合格することは難しいようですね。Royalholidayclubbedの助けのもとで君は大量のお金と時間を费やさなくても復楽にCiscoの350-401日本語版トレーリング認定試験に合格のは大丈夫でしょう。ソフトの問題集はRoyalholidayclubbedが実際問題によって、テストの問題と解答を分析して出来上がりました。Royalholidayclubbedが提供したCiscoの350-401日本語版トレーリングの問題集は真実の試験に緊密な相似性があります。
もし不合格になったら、私たちは全額返金することを保証します。一回だけでCiscoの350-401日本語版トレーリング試験に合格したい?Royalholidayclubbedは君の欲求を満たすために存在するのです。
350-401 PDF DEMO:QUESTION NO: 1 Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model? A. IPsec B. Cisco Trustsec C. MACsec D. SSL Answer: C Explanation: MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of -band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre Shared Key (PSK) framework. A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a MKA peer) using the current session key. Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16- 9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 2 To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller. Which EtherChannel mode must be configured on the switch to allow the WLC to connect? A. Active B. On C. Auto D. Passive Answer: B Explanation: Restrictions for Link Aggregation: You can bundle all eight ports on a Cisco 5508 Controller into a single link. Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group. LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch. Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller. If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller. https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 3 Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are mode, the port channel does not establish. Based on the configuration excerpt of SW3, what is the cause of the problem? A. The port-channel interface lead balance should be set to src-mac B. The port-channel trunk is not allowing the native VLAN. C. The port-channel should be set to auto. D. The port channel on SW2 is using an incompatible protocol. Answer: D Explanation: The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 4 What is the difference between a RIB and a FIB? A. The FIB is populated based on RIB content B. The RIB is used to make IP source prefix-based switching decisions C. The RIB maintains a mirror image of the FIB D. The FIB is where all IP routing information is stored Answer: A Explanation: CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions. The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching. Note: In order to view the Routing information base (RIB) table, use the "show ip route" command. To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5 Which statement about multicast RPs is true? A. RPs are required for protocol independent multicast sparse mode and dense mode. B. By default, the RP is needed only to start new sessions with sources and receivers. C. By default, the RP is needed periodically to maintain sessions with sources and receivers D. RPs are required only when using protocol independent multicast dense mode. Answer: B Explanation: A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM). By default, the RP is needed only to start new sessions with sources and receivers. Reference: https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
もし君がCiscoのHP HPE2-N71に参加すれば、良い学習のツルを選ぶすべきです。 RoyalholidayclubbedのCiscoのCisco 300-415J試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。 NVIDIA NCP-AIN - 何の問題があったらお気軽に聞いてください。 Salesforce CRT-211 - 時間とお金の集まりより正しい方法がもっと大切です。 あなたはきっとCiscoのSalesforce CRT-211-JPN試験に合格できますから。
Updated: May 28, 2022
|
|