350-401日本語版テキスト内容 & 350-401模擬試験最新版 - 350-401キャリアパス - Royalholidayclubbed

RHC Destination Reviews

Who Is Harpy?

Need More Information?

RoyalholidayclubbedはCiscoの350-401日本語版テキスト内容認定試験に便利なサービスを提供するサイトで、従来の試験によってRoyalholidayclubbed が今年のCiscoの350-401日本語版テキスト内容認定試験を予測してもっとも真実に近い問題集を研究し続けます。あなたは350-401日本語版テキスト内容試験に不安を持っていますか？350-401日本語版テキスト内容参考資料をご覧下さい。私たちの350-401日本語版テキスト内容参考資料は十年以上にわたり、専門家が何度も練習して、作られました。 Ciscoの350-401日本語版テキスト内容認定試験に準備する練習ツールや訓練機関に通学しなればまりませんでしょう。

CCNP Enterprise 350-401 Royalholidayclubbedには専門的なエリート団体があります。

CCNP Enterprise 350-401日本語版テキスト内容 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 当社の製品を利用したら、一年間の無料更新サービスを提供します。試験の目標が変わる限り、あるいは我々の勉強資料が変わる限り、すぐに更新して差し上げます。あなたのニーズをよく知っていていますから、あなたに試験に合格する自信を与えます。

順調にIT認定試験に合格したいなら、Royalholidayclubbedはあなたの唯一の選択です。Royalholidayclubbedに提供されている資料はIT認定試験に対して10年過ぎの経験を持っているプロフェッショナルによって研究と実践を通じて作成し出されたものです。Royalholidayclubbedは最新かつ最も正確な試験350-401日本語版テキスト内容問題集を用意しておきます。

それはもちろんRoyalholidayclubbedのCisco 350-401日本語版テキスト内容問題集ですよ。

Royalholidayclubbedの350-401日本語版テキスト内容問題集は多くの受験生に検証されたものですから、高い成功率を保証できます。もしこの問題集を利用してからやはり試験に不合格になってしまえば、Royalholidayclubbedは全額で返金することができます。あるいは、無料で試験350-401日本語版テキスト内容問題集を更新してあげるのを選択することもできます。こんな保障がありますから、心配する必要は全然ないですよ。

Ciscoの350-401日本語版テキスト内容問題集は350-401日本語版テキスト内容に関する問題をほとんど含まれます。私たちのCiscoの350-401日本語版テキスト内容問題集を使うのは君のベストな選択です。

350-401 PDF DEMO:

QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 5
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

RoyalholidayclubbedのITエリートたちは彼らの専門的な目で、最新的なCiscoのCompTIA 220-1201試験トレーニング資料に注目していて、うちのCiscoのCompTIA 220-1201問題集の高い正確性を保証するのです。 ServiceNow CIS-EM - Royalholidayclubbedを選ぶなら、成功を選ぶのに等しいです。 CiscoのNVIDIA NCA-GENL認定試験に合格することはきっと君の職業生涯の輝い将来に大変役に立ちます。それを利用したら、君のCiscoのATD CPTD認定試験に合格するのは問題ありません。 The Open Group OGEA-101 - 正しい方法は大切です。

Updated: May 28, 2022

by RHC.

---------------

If you don't find what you are looking for here

to help you resolve your timeshare scam or Royal Holiday problem

please write to us at:

harpy @ royalholidayclubbed.com

Link Partner Directory

www . Royal Holiday Clubbed . com

sitemap