|
|
 |
350-401日本語版と英語版 & Cisco Implementing Cisco Enterprise Network Core Technologies 350-401 Encor模擬体験 - Royalholidayclubbed
|
|
RHC Destination Reviews
Who Is Harpy?
Need More Information?
調査、研究を経って、IT職員の月給の増加とジョブのプロモーションはCisco 350-401日本語版と英語版資格認定と密接な関係があります。給料の増加とジョブのプロモーションを真になるために、RoyalholidayclubbedのCisco 350-401日本語版と英語版問題集を勉強しましょう。いつまでも350-401日本語版と英語版試験に準備する皆様に便宜を与えるRoyalholidayclubbedは、高品質の試験資料と行き届いたサービスを提供します。 RoyalholidayclubbedのCiscoの350-401日本語版と英語版の試験問題は同じシラバスに従って、実際のCiscoの350-401日本語版と英語版認証試験にも従っています。弊社はずっとトレーニング資料をアップグレードしていますから、提供して差し上げた製品は一年間の無料更新サービスの景品があります。 あなたはいつまでも最新版の問題集を使用できるために、ご購入の一年間で無料の更新を提供します。
CCNP Enterprise 350-401 どんな困難にあっても、諦めないです。
CCNP Enterprise 350-401日本語版と英語版 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) IT認証は同業種の欠くことができないものになりました。 そのデモは350-401 試験感想試験資料の一部を含めています。私たちは本当にお客様の貴重な意見を350-401 試験感想試験資料の作りの考慮に入れます。
Royalholidayclubbedに会ったら、最高のトレーニング資料を見つけました。RoyalholidayclubbedのCiscoの350-401日本語版と英語版試験トレーニング資料を持っていたら、試験に対する充分の準備がありますから、安心に利用したください。Royalholidayclubbedは優れたIT情報のソースを提供するサイトです。
Cisco 350-401日本語版と英語版認定試験に合格することは難しいようですね。
Royalholidayclubbedの助けのもとで君は大量のお金と時間を费やさなくても復楽にCiscoの350-401日本語版と英語版認定試験に合格のは大丈夫でしょう。ソフトの問題集はRoyalholidayclubbedが実際問題によって、テストの問題と解答を分析して出来上がりました。Royalholidayclubbedが提供したCiscoの350-401日本語版と英語版の問題集は真実の試験に緊密な相似性があります。
もし不合格になったら、私たちは全額返金することを保証します。一回だけでCiscoの350-401日本語版と英語版試験に合格したい？Royalholidayclubbedは君の欲求を満たすために存在するのです。
350-401 PDF DEMO:
QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 2
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
CiscoのFortinet FCSS_EFW_AD-7.4認定試験はIT業界の中でとても重要な認証試験で、合格するために良い訓練方法で準備をしなければなりません。 RoyalholidayclubbedのCiscoのMicrosoft AI-900試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。 IFSE Institute LLQP - Royalholidayclubbedは１００％の合格率を保証するだけでなく、1年間の無料なオンラインの更新を提供しております。 EMC D-FEN-F-00 - 我々の誠意を信じてください。 あなたはきっとCiscoのFortinet FCSS_LED_AR-7.6試験に合格できますから。
Updated: May 28, 2022
|
Copyright © 2006-2007 by RHC.
All rights
reserved. |
---------------
If you don't find what you are looking for here
to help you resolve your timeshare scam or Royal Holiday problem
please write to us at:
harpy @ royalholidayclubbed.com
www . Royal Holiday Clubbed . com
|
|