Home
My
$18,000 Timeshare Story
Objectives
The
Power Of Two
Other
People's Stories
Important
Links
Timeshare
Articles
RHC
Destination Reviews
Who
Is Harpy?
Write
To Harpy
Throw
Harpy A Fish!
The
Timeshare Club
Bookmark
this site
Need
More Information?
|
気楽に試験に合格したければ、はやく試しに来てください。350-401日本語問題集認定試験に合格することは難しいようですね。試験を申し込みたいあなたは、いまどうやって試験に準備すべきなのかで悩んでいますか。 他の人に先立ってCisco 350-401日本語問題集認定資格を得るために、今から勉強しましょう。明日ではなく、今日が大事と良く知られるから、そんなにぐずぐずしないで早く我々社のCisco 350-401日本語問題集日本語対策問題集を勉強し、自身を充実させます。 Royalholidayclubbedは君にとってベストな選択になります。
CCNP Enterprise 350-401 最もよくて最新で資料を提供いたします。Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)日本語問題集試験を準備しているあなたに試験に合格させるために、我々Royalholidayclubbedは模擬試験ソフトを更新し続けています。 多くのCiscoの350-401 トレーニング認定試験を準備している受験生がいろいろな350-401 トレーニング「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験についてサービスを提供するサイトオンラインがみつけたがRoyalholidayclubbedはIT業界トップの専門家が研究した参考材料で権威性が高く、品質の高い教育資料で、一回に参加する受験者も合格するのを確保いたします。
心はもはや空しくなく、生活を美しくなります。世の中に去年の自分より今年の自分が優れていないのは立派な恥です。それで、IT人材として毎日自分を充実して、350-401日本語問題集問題集を学ぶ必要があります。
Cisco 350-401日本語問題集 - Royalholidayclubbedには専門的なエリート団体があります。Royalholidayclubbedの350-401日本語問題集問題集はあなたの一発合格を保証できる資料です。問題集の的中率はとても高いですから、この問題集だけで試験に合格することができます。信じられなら利用してみてください。不合格になればRoyalholidayclubbedは全額返金のことができますから、絶対損にならないです。利用したら350-401日本語問題集問題集の品質がわかるようになるので、まず問題集の無料なサンプルを試しましょう。問題集のdemoが無料で提供されますから、Royalholidayclubbedのサイトをクリックしてダウンロードしてください。
RoyalholidayclubbedのCiscoの350-401日本語問題集試験トレーニング資料を手に入れたら、我々は一年間の無料更新サービスを提供します。それはあなたがいつでも最新の試験資料を持てるということです。
350-401 PDF DEMO:QUESTION NO: 1 Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are mode, the port channel does not establish. Based on the configuration excerpt of SW3, what is the cause of the problem? A. The port-channel interface lead balance should be set to src-mac B. The port-channel trunk is not allowing the native VLAN. C. The port-channel should be set to auto. D. The port channel on SW2 is using an incompatible protocol. Answer: D Explanation: The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2 Which statement about multicast RPs is true? A. RPs are required for protocol independent multicast sparse mode and dense mode. B. By default, the RP is needed only to start new sessions with sources and receivers. C. By default, the RP is needed periodically to maintain sessions with sources and receivers D. RPs are required only when using protocol independent multicast dense mode. Answer: B Explanation: A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM). By default, the RP is needed only to start new sessions with sources and receivers. Reference: https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3 Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model? A. IPsec B. Cisco Trustsec C. MACsec D. SSL Answer: C Explanation: MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of -band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre Shared Key (PSK) framework. A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a MKA peer) using the current session key. Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16- 9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4 To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller. Which EtherChannel mode must be configured on the switch to allow the WLC to connect? A. Active B. On C. Auto D. Passive Answer: B Explanation: Restrictions for Link Aggregation: You can bundle all eight ports on a Cisco 5508 Controller into a single link. Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group. LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch. Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller. If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller. https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5 Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80? A. Deny tcp any any ne 80 Permit tcp any any range 22 443 B. Permit tcp any any ne 80 C. Permit tco any any range 22 443 Deny tcp any any eq 80 D. Deny tcp any any eq 80 Permit tco any any gt 21 it 444 Answer: D
Lpi 030-100J認定試験の準備を完了したのですか。 RoyalholidayclubbedのCiscoのHuawei H19-621_V2.0試験トレーニング資料は最高のトレーニング資料です。 受験生が最も早い時間で、一回だけでCiscoのCIPS L5M4認定試験に合格できるために、Royalholidayclubbedはずっとがんばります。 Pegasystems PEGACPBA24V1 - Royalholidayclubbedはあなたが試験に合格するのを助けることができるだけでなく、あなたは最新の知識を学ぶのを助けることもできます。 もしCiscoのSalesforce Service-Cloud-Consultant-JPN問題集は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。
Updated: May 28, 2022
|
|