350-401技術問題、Cisco 350-401学習教材 & Implementing Cisco Enterprise Network Core Technologies 350-401 Encor - Royalholidayclubbed

 

Home

My $18,000 Timeshare Story

Objectives

The Power Of Two

 

Other People's Stories

Important Links

  

Timeshare Articles

  

RHC Destination Reviews

  

Who Is Harpy?

Write To Harpy

Throw Harpy A Fish!

  

The Timeshare Club

 

Bookmark this site

 

Need More Information?

Royalholidayclubbedはきみの貴重な時間を節約するだけでなく、 安心で順調に試験に合格するのを保証します。Royalholidayclubbedは専門のIT業界での評判が高くて、あなたがインターネットでRoyalholidayclubbedの部分のCisco 350-401技術問題「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」資料を無料でダウンロードして、弊社の正確率を確認してください。弊社の商品が好きなのは弊社のたのしいです。 RoyalholidayclubbedのCiscoの350-401技術問題試験トレーニング資料は間違いなく最高のトレーニング資料ですから、それを選ぶことはあなたにとって最高の選択です。IT専門家になりたいですか。 Royalholidayclubbed を選択して100%の合格率を確保することができて、もし試験に失敗したら、Royalholidayclubbedが全額で返金いたします。

CCNP Enterprise 350-401 早くRoyalholidayclubbedの問題集を君の手に入れましょう。

Royalholidayclubbedの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)技術問題問題集を入手してから、非常に短い時間で試験に準備しても、あなたは順調に試験に合格することができます。 君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにRoyalholidayclubbedを選択してください。Royalholidayclubbedはまた一年間に無料なサービスを更新いたします。

あなたを試験に一発合格させる素晴らしい350-401技術問題試験に関連する参考書が登場しますよ。それはRoyalholidayclubbedの350-401技術問題問題集です。気楽に試験に合格したければ、はやく試しに来てください。

CiscoのCisco 350-401技術問題試験に合格するのは最良の方法の一です。

Royalholidayclubbedの350-401技術問題問題集は多くの受験生に検証されたものですから、高い成功率を保証できます。もしこの問題集を利用してからやはり試験に不合格になってしまえば、Royalholidayclubbedは全額で返金することができます。あるいは、無料で試験350-401技術問題問題集を更新してあげるのを選択することもできます。こんな保障がありますから、心配する必要は全然ないですよ。

我々の共同の努力はあなたに順調にCiscoの350-401技術問題試験に合格させることができます。時々重要な試験に合格するために大量の問題をする必要があります。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

SAP C_TS470_2412 - なぜ受験生のほとんどはRoyalholidayclubbedを選んだのですか。 Google Apigee-API-Engineer - それで、不必要な損失を避けできます。 RoyalholidayclubbedのCiscoのAmazon AIF-C01問題集を購入するなら、君がCiscoのAmazon AIF-C01認定試験に合格する率は100パーセントです。 その他、Microsoft AZ-104試験認証証明書も仕事昇進にたくさんのメリットを与えられます。 購入した前の無料の試み、購入するときのお支払いへの保障、購入した一年間の無料更新CiscoのCompTIA CS0-003試験に失敗した全額での返金…これらは我々のお客様への承諾です。

Updated: May 28, 2022

 

Copyright © 2006-2007

by RHC.

All rights reserved.
Revised: 21 Oct 2007

 

---------------

Google
 
Web www.RoyalHolidayClubbed.com

If you don't find what you are looking for here

to help you resolve your timeshare scam or Royal Holiday problem

please write to us at:

harpy @ royalholidayclubbed.com

Link Partner Directory

Privacy Policy

www . Royal Holiday Clubbed . com

Related Posts

 

sitemap