|
|
 |
350-401復習問題集 & Cisco Implementing Cisco Enterprise Network Core Technologies 350-401 Encor模擬解説集 - Royalholidayclubbed
|
|
RHC Destination Reviews
Who Is Harpy?
Need More Information?
もしそうだったら、もう試験に合格できないなどのことを心配する必要がないのです。ずっと自分自身を向上させたいあなたは、350-401復習問題集認定試験を受験する予定があるのですか。もし受験したいなら、試験の準備をどのようにするつもりですか。 弊社の350-401復習問題集問題集はあなたにこのチャンスを全面的に与えられます。あなたは自分の望ましいCisco 350-401復習問題集問題集を選らんで、学びから更なる成長を求められます。 不合格になる場合或いはCiscoの350-401復習問題集問題集がどんな問題があれば、私たちは全額返金することを保証いたします。
CCNP Enterprise 350-401 弊社の商品が好きなのは弊社のたのしいです。
CCNP Enterprise 350-401復習問題集 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 我々はあなたのIT業界での発展にヘルプを提供できると希望します。 Royalholidayclubbed を選択して１００％の合格率を確保することができて、もし試験に失敗したら、Royalholidayclubbedが全額で返金いたします。
あなたは自分の望ましいCisco 350-401復習問題集問題集を選らんで、学びから更なる成長を求められます。心はもはや空しくなく、生活を美しくなります。世の中に去年の自分より今年の自分が優れていないのは立派な恥です。
Cisco 350-401復習問題集 - Royalholidayclubbedを選んだら、成功への扉を開きます。
君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにRoyalholidayclubbedを選択してください。Royalholidayclubbedはまた一年間に無料なサービスを更新いたします。
そうすると、あなたがいつでも最新バージョンの資料を持っていることが保証されます。Royalholidayclubbedはあなたが試験に合格するのを助けることができるだけでなく、あなたは最新の知識を学ぶのを助けることもできます。
350-401 PDF DEMO:
QUESTION NO: 1
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 2
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
CompTIA SY0-701-JPN - 受験者はRoyalholidayclubbedを通って順調に試験に合格する人がとても多くなのでRoyalholidayclubbedがIT業界の中で高い名声を得ました。 RoyalholidayclubbedのGenesys GCX-GCD問題集は多くの受験生に検証されたものですから、高い成功率を保証できます。 ISTQB CTAL-TM-001-KR - Ciscoの認証試験の合格書を取ってから更にあなたのIT業界での仕事にとても助けがあると思います。 RoyalholidayclubbedのITエリートたちは彼らの専門的な目で、最新的なCiscoのAmazon SAP-C02-KR試験トレーニング資料に注目していて、うちのCiscoのAmazon SAP-C02-KR問題集の高い正確性を保証するのです。 IAPP AIGP - もし試験に失敗したら、弊社が全額で返金いたします。
Updated: May 28, 2022
|
Copyright © 2006-2007 by RHC.
All rights
reserved. |
---------------
If you don't find what you are looking for here
to help you resolve your timeshare scam or Royal Holiday problem
please write to us at:
harpy @ royalholidayclubbed.com
www . Royal Holiday Clubbed . com
|
|