350-401学習指導 - Cisco Implementing Cisco Enterprise Network Core Technologies 350-401 Encor日本語版復習資料 - Royalholidayclubbed

RHC Destination Reviews

Who Is Harpy?

Need More Information?

Cisco 350-401学習指導「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に合格することが簡単ではなくて、Cisco 350-401学習指導証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。しようがないわけではないです。短時間の準備でも楽に試験に合格することができるようになりますよ。今の社会の中で、ネット上で訓練は普及して、弊社は試験問題集を提供する多くのネットの一つでございます。

CCNP Enterprise 350-401 夢を持ったら実現するために頑張ってください。

CCNP Enterprise 350-401学習指導 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) そうであれば、あなたは夢がある人だと思います。最近、Ciscoの350-401 問題無料試験は非常に人気のある認定試験です。あなたもこの試験の認定資格を取得したいのですか。

我々RoyalholidayclubbedのITエリートと我々のCiscoの350-401学習指導試験のソフトに満足するお客様は我々に自信を持たせます。あなたのCiscoの350-401学習指導試験を準備する圧力を減少するのは我々の責任で、あなたにCiscoの350-401学習指導試験に合格させるのは我々の目標です。我々はほぼ100％の通過率であなたに安心させます。

そして、Cisco 350-401学習指導問題集は安くて、便利です。

我々のCiscoの350-401学習指導ソフトを利用してお客様の高通過率及び我々の技術の高いチームで、我々は自信を持って我々Royalholidayclubbedは専門的なのだと言えます。アフターサービスは会社を評価する重要な基準です。これをよくできるために、我々は全日24時間のサービスを提供します。Ciscoの350-401学習指導ソフトを購入してから一年間の無料更新サービスも提供します。試験に失敗したら、全額で返金する承諾があります。だから、Ciscoの350-401学習指導試験に合格したいあなたは安心で弊社の商品を選べばいいんです。

でも、Cisco　350-401学習指導復習教材を選ばれば、試験に合格することは簡単です。350-401学習指導復習教材の内容は全面的で、価格は合理的です。

350-401 PDF DEMO:

QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 5
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

SAP C-FIORD-2502 - すべては豊富な内容があって各自のメリットを持っています。 CiscoのHuawei H19-638_V1.0の認定試験に合格すれば、就職機会が多くなります。我々RoyalholidayclubbedはCiscoのHuawei H20-699_V2.0試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。 ATLASSIAN ACP-120 - 彼らはRoyalholidayclubbedの問題集が有効なこと確認しました。競争力が激しい社会に当たり、我々Royalholidayclubbedは多くの受験生の中で大人気があるのは受験生の立場からCisco　Alcatel-Lucent 4A0-100試験資料をリリースすることです。

Updated: May 28, 2022

by RHC.

---------------

If you don't find what you are looking for here

to help you resolve your timeshare scam or Royal Holiday problem

please write to us at:

harpy @ royalholidayclubbed.com

Link Partner Directory

www . Royal Holiday Clubbed . com

sitemap