350-401ミシュレーション問題 & 350-401基礎訓練、350-401日本語参考 - Royalholidayclubbed

RHC Destination Reviews

Who Is Harpy?

Need More Information?

試験問題と解答に関する質問があるなら、当社は直後に解決方法を差し上げます。しかも、一年間の無料更新サービスを提供します。Royalholidayclubbedは実際の環境で本格的なCiscoの350-401ミシュレーション問題「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」の試験の準備過程を提供しています。長年の努力を通じて、RoyalholidayclubbedのCiscoの350-401ミシュレーション問題認定試験の合格率が１００パーセントになっていました。Ciscoの350-401ミシュレーション問題試験の認定はIT業種で不可欠な認定で、あなたはCiscoの350-401ミシュレーション問題認定試験に合格するのに悩んでいますか。 RoyalholidayclubbedのCiscoの350-401ミシュレーション問題試験問題資料は質が良くて値段が安い製品です。

CCNP Enterprise 350-401 そうであれば、あなたは夢がある人だと思います。

最近、Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)ミシュレーション問題試験は非常に人気のある認定試験です。我々RoyalholidayclubbedのITエリートと我々のCiscoの350-401 ソフトウエア試験のソフトに満足するお客様は我々に自信を持たせます。あなたのCiscoの350-401 ソフトウエア試験を準備する圧力を減少するのは我々の責任で、あなたにCiscoの350-401 ソフトウエア試験に合格させるのは我々の目標です。

Royalholidayclubbedの350-401ミシュレーション問題教材を購入したら、あなたは一年間の無料アップデートサービスを取得しました。試験問題集が更新されると、Royalholidayclubbedは直ちにあなたのメールボックスに350-401ミシュレーション問題問題集の最新版を送ります。あなたは試験の最新バージョンを提供することを要求することもできます。

Cisco 350-401ミシュレーション問題 - あなたは最高のトレーニング資料を手に入れました。

近年、IT領域で競争がますます激しくなります。IT認証は同業種の欠くことができないものになりました。あなたはキャリアで良い昇進のチャンスを持ちたいのなら、RoyalholidayclubbedのCiscoの350-401ミシュレーション問題「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験トレーニング資料を利用してCiscoの認証の証明書を取ることは良い方法です。現在、Ciscoの350-401ミシュレーション問題認定試験に受かりたいIT専門人員がたくさんいます。Royalholidayclubbedの試験トレーニング資料はCiscoの350-401ミシュレーション問題認定試験の１００パーセントの合格率を保証します。

あなたはRoyalholidayclubbedの350-401ミシュレーション問題問題集を利用することができますから。「今の生活と仕事は我慢できない。

350-401 PDF DEMO:

QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 5
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

Adobe AD0-E907 - Royalholidayclubbedは優れたIT情報のソースを提供するサイトです。それは RoyalholidayclubbedのPalo Alto Networks PCNSE-JPN問題集には実際の試験に出題される可能性がある問題をすべて含んでいて、しかもあなたをよりよく問題を理解させるように詳しい解析を与えますから。 RoyalholidayclubbedのSAP C_WME_2506問題集の合格率が100%に達することも数え切れない受験生に証明された事実です。 H3C GB0-713-ENU - 不思議でしょう。あなたを試験に一発合格させる素晴らしいFortinet FCSS_CDS_AR-7.6試験に関連する参考書が登場しますよ。

Updated: May 28, 2022

by RHC.

---------------

If you don't find what you are looking for here

to help you resolve your timeshare scam or Royal Holiday problem

please write to us at:

harpy @ royalholidayclubbed.com

Link Partner Directory

www . Royal Holiday Clubbed . com

sitemap