|
|
 |
200-301過去問無料 - 200-301最新受験攻略 & Cisco Certified Network Associate Exam - Royalholidayclubbed
|
|
RHC Destination Reviews
Who Is Harpy?
Need More Information?
RoyalholidayclubbedのCiscoの200-301過去問無料試験トレーニング資料を手に入れたら、成功に導く鍵を手に入れるのに等しいです。もしあなたはIT業種でもっと勉強になりたいなら、Royalholidayclubbedを選んだ方が良いです。RoyalholidayclubbedのCiscoの200-301過去問無料試験トレーニング資料は豊富な経験を持っている専門家が長年の研究を通じて開発されたものです。 暇な時間だけでCiscoの200-301過去問無料試験に合格したいのですか。我々の提供するPDF版のCiscoの200-301過去問無料試験の資料はあなたにいつでもどこでも読めさせます。 弊社のソフトは買うたるかどうかまだ疑問がありますか。
CCNA 200-301 あなたの気に入る版を選ぶことができます。
競争力が激しい社会に当たり、我々Royalholidayclubbedは多くの受験生の中で大人気があるのは受験生の立場からCisco 200-301 - Cisco Certified Network Associate Exam過去問無料試験資料をリリースすることです。 試験が更新されているうちに、我々はCiscoの200-301 問題無料試験の資料を更新し続けています。できるだけ100％の通過率を保証使用にしています。
200-301過去問無料問題集を利用して試験に合格できます。この問題集の合格率は高いので、多くのお客様から200-301過去問無料問題集への好評をもらいました。200-301過去問無料問題集のカーバー率が高いので、勉強した問題は試験に出ることが多いです。
あなたにCiscoのCisco 200-301過去問無料試験に自信を持たせます。
RoyalholidayclubbedにたくさんのIT専門人士がいって、弊社の問題集に社会のITエリートが認定されて、弊社の問題集は試験の大幅カーバして、合格率が１００％にまで達します。弊社のみたいなウエブサイトが多くても、彼たちは君の学習についてガイドやオンラインサービスを提供するかもしれないが、弊社はそちらにより勝ちます。Royalholidayclubbedは同業の中でそんなに良い地位を取るの原因は弊社のかなり正確な試験の練習問題と解答そえに迅速の更新で、このようにとても良い成績がとられています。そして、弊社が提供した問題集を安心で使用して、試験を安心で受けて、君のCisco 200-301過去問無料認証試験の１００％の合格率を保証しますす。
成功を受けたいあなたはすぐに行動しませんでしょうか？200-301過去問無料試験に興味があると、我々社Royalholidayclubbedをご覧になってください。古くから成功は準備のできる人のためにあると聞こえます。
200-301 PDF DEMO:
QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 2
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 3
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 4
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
CiscoのISTQB CTAL_TM_001試験に合格することは容易なことではなくて、良い訓練ツールは成功の保証でRoyalholidayclubbedは君の試験の問題を準備してしまいました。 疑問があると、Huawei H19-633_V2.0問題集デーモによる一度やってみてください。 Huawei H20-911_V1.0 - Royalholidayclubbedはあなたの夢に実現させるサイトでございます。 高品質のCisco ISTQB CTAL-TM-001練習問題はあなたが迅速に試験に合格させます。 Oracle 1Z1-922 - 模擬テスト問題集と真実の試験問題がよく似ています。
Updated: May 28, 2022
|
Copyright © 2006-2007 by RHC.
All rights
reserved. |
---------------
If you don't find what you are looking for here
to help you resolve your timeshare scam or Royal Holiday problem
please write to us at:
harpy @ royalholidayclubbed.com
www . Royal Holiday Clubbed . com
|
|