|
|
 |
200-301資格講座、200-301問題数 - Cisco 200-301参考資料 - Royalholidayclubbed
|
|
RHC Destination Reviews
Who Is Harpy?
Need More Information?
我々はあなたに提供するのは最新で一番全面的なCiscoの200-301資格講座問題集で、最も安全な購入保障で、最もタイムリーなCiscoの200-301資格講座試験のソフトウェアの更新です。無料デモはあなたに安心で購入して、購入した後1年間の無料Ciscoの200-301資格講座試験の更新はあなたに安心で試験を準備することができます、あなたは確実に購入を休ませることができます私たちのソフトウェアを試してみてください。もちろん、我々はあなたに一番安心させるのは我々の開発する多くの受験生に合格させるCiscoの200-301資格講座試験のソフトウェアです。 そうしたら、この資料があなたに適用するかどうかを確かめてから購入することができます。RoyalholidayclubbedのCiscoの200-301資格講座試験トレーニング資料を利用してから失敗になりましたら、当社は全額で返金します。 Ciscoの200-301資格講座の購入の前にあなたの無料の試しから、購入の後での一年間の無料更新まで我々はあなたのCiscoの200-301資格講座試験に一番信頼できるヘルプを提供します。
安心に200-301資格講座試験を申し込みましょう。
自分の能力を証明するために、200-301 - Cisco Certified Network Associate Exam資格講座試験に合格するのは不可欠なことです。 テストエンジンとして、ソフトウェア版の200-301 資格勉強問題集はあなたの試験の準備についての進捗状況をテストするために利用することができます。もし試験の準備を十分にしたかどうかを確認したいなら、ソフトウェア版の200-301 資格勉強問題集を利用して自分のレベルをテストしてください。
我々Royalholidayclubbedは一番行き届いたアフタサービスを提供します。Cisco 200-301資格講座試験問題集を購買してから、一年間の無料更新を楽しみにしています。あなたにCisco 200-301資格講座試験に関する最新かつ最完備の資料を勉強させ、試験に合格させることだと信じます。
Cisco 200-301資格講座 - こうして、君は安心で試験の準備を行ってください。
他人の話を大切にしないで重要なのは自分の感じです。あなたに我々の誠意を感じさせるために、弊社は無料のCiscoの200-301資格講座ソフトを提供して、ご購入の前にデモを利用してみてあなたに安心させます。最高のアフターサービスも提供します。Ciscoの200-301資格講座ソフトが更新されたら、もうすぐあなたに送っています。あなたに一年間の無料更新サービスを提供します。
Cisco 200-301資格講座「Cisco Certified Network Associate Exam」認証試験に合格することが簡単ではなくて、Cisco 200-301資格講座証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。
200-301 PDF DEMO:
QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 2
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 3
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 4
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
QUESTION NO: 5
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
だから、CiscoのATLASSIAN ACP-620試験に合格したいあなたは安心で弊社の商品を選べばいいんです。 Microsoft SC-200 - 今の社会の中で、ネット上で訓練は普及して、弊社は試験問題集を提供する多くのネットの一つでございます。 そのほかに、どのバーションでも全面的で最新版のCiscoのIIBA ECBA-JPNの資料を提供します。 Royalholidayclubbedは実際の環境で本格的なCiscoのSAP C-AIG-2412「Cisco Certified Network Associate Exam」の試験の準備過程を提供しています。 初心者にとって、SAP C_OCM_2503試験に合格するのはそんなに難しいことですか？実は、我々RoyalholidayclubbedのSAP C_OCM_2503問題集を選んで利用し、お客様は力の限りまで勉強して、合格しやすいです。
Updated: May 28, 2022
|
Copyright © 2006-2007 by RHC.
All rights
reserved. |
---------------
If you don't find what you are looking for here
to help you resolve your timeshare scam or Royal Holiday problem
please write to us at:
harpy @ royalholidayclubbed.com
www . Royal Holiday Clubbed . com
|
|