|
|
 |
200-301資格参考書、200-301テキスト - Cisco 200-301合格体験記 - Royalholidayclubbed
|
|
RHC Destination Reviews
Who Is Harpy?
Need More Information?
時間とお金の集まりより正しい方法がもっと大切です。Ciscoの200-301資格参考書試験のために勉強していますなら、Royalholidayclubbedの提供するCiscoの200-301資格参考書試験ソフトはあなたの選びの最高です。我々の目的はあなたにCiscoの200-301資格参考書試験に合格することだけです。 弊社のRoyalholidayclubbedで無料でCiscoの200-301資格参考書ソフトのデモを直ちにダウンロードできます。Ciscoの200-301資格参考書ソフトを利用してこのソフトはあなたの愛用するものになることを信じています。 Ciscoの200-301資格参考書試験を準備しているあなたに試験に合格させるために、我々Royalholidayclubbedは模擬試験ソフトを更新し続けています。
CCNA 200-301 それはあなたが夢を実現することを助けられます。
CCNA 200-301資格参考書 - Cisco Certified Network Associate Exam 常々、時間とお金ばかり効果がないです。 あなたは自分の知識レベルを疑っていて試験の準備をする前に詰め込み勉強しているときに、自分がどうやって試験に受かることを確保するかを考えましたか。心配しないでください。
Royalholidayclubbedは多くの受験生を助けて彼らにCiscoの200-301資格参考書試験に合格させることができるのは我々専門的なチームがCiscoの200-301資格参考書試験を研究して解答を詳しく分析しますから。試験が更新されているうちに、我々はCiscoの200-301資格参考書試験の資料を更新し続けています。できるだけ100％の通過率を保証使用にしています。
Cisco 200-301資格参考書 - 暇の時間を利用して勉強します。
Ciscoの200-301資格参考書試験の認定はIT業種で欠くことができない認証です。では、どうやって、最も早い時間でCiscoの200-301資格参考書認定試験に合格するのですか。Royalholidayclubbedは君にとって最高な選択になっています。RoyalholidayclubbedのCiscoの200-301資格参考書試験トレーニング資料はRoyalholidayclubbedのIT専門家たちが研究して、実践して開発されたものです。その高い正確性は言うまでもありません。もし君はいささかな心配することがあるなら、あなたはうちの商品を購入する前に、Royalholidayclubbedは無料でサンプルを提供することができます。
そして、200-301資格参考書試験参考書の問題は本当の試験問題とだいたい同じことであるとわかります。200-301資格参考書試験参考書があれば,ほかの試験参考書を勉強する必要がないです。
200-301 PDF DEMO:
QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 2
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 3
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 4
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
もしCiscoのPeoplecert ITIL-4-Practitioner-Release-Management問題集は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。 CiscoのCisco 200-301-KRの認定試験に合格すれば、就職機会が多くなります。 CiscoのSalesforce Service-Cloud-Consultant-JPN試験ソフトを買ったあなたは一年間の無料更新サービスを得られて、CiscoのSalesforce Service-Cloud-Consultant-JPNの最新の問題集を了解して、試験の合格に自信を持つことができます。 SAP C-S4CFI-2504 - あなたの全部な需要を満たすためにいつも頑張ります。 なぜ我々のCiscoのNutanix NCP-USソフトに自信があるかと聞かれたら、まずは我々Royalholidayclubbedの豊富な経験があるチームです、次は弊社の商品を利用してCiscoのNutanix NCP-US試験に合格する多くのお客様です。
Updated: May 28, 2022
|
Copyright © 2006-2007 by RHC.
All rights
reserved. |
---------------
If you don't find what you are looking for here
to help you resolve your timeshare scam or Royal Holiday problem
please write to us at:
harpy @ royalholidayclubbed.com
www . Royal Holiday Clubbed . com
|
|