200-301認定資格試験問題集 - Cisco 200-301資格認定 & Cisco Certified Network Associate Exam - Royalholidayclubbed

 

Home

My $18,000 Timeshare Story

Objectives

The Power Of Two

 

Other People's Stories

Important Links

  

Timeshare Articles

  

RHC Destination Reviews

  

Who Is Harpy?

Write To Harpy

Throw Harpy A Fish!

  

The Timeshare Club

 

Bookmark this site

 

Need More Information?

Royalholidayclubbedというサイトです。Royalholidayclubbedの Ciscoの200-301認定資格試験問題集試験資料を利用したら、時間を節約することができるようになります。我々はあなたに向いて適当の資料を選びます。 Royalholidayclubbedはずっと君のために最も正確なCiscoの200-301認定資格試験問題集「Cisco Certified Network Associate Exam」試験に関する資料を提供して、君が安心に選択することができます。君はオンラインで無料な練習問題をダウンロードできて、100%で試験に合格しましょう。 Royalholidayclubbedはあなたと苦楽を共にして、一緒に挑戦に直面します。

CCNA 200-301 では、どうしたらいいでしょうか。

それはコストパフォーマンスが非常に高い資料ですから、もしあなたも私と同じIT夢を持っていたら、RoyalholidayclubbedのCiscoの200-301 - Cisco Certified Network Associate Exam認定資格試験問題集試験トレーニング資料を利用してください。 はCiscoの200-301 試験番号試験に合格するのに、私たちは最も早い時間で合格するのを追求します。

さて、はやく試験を申し込みましょう。Royalholidayclubbedはあなたを助けることができますから、心配する必要がないですよ。あなたの夢は何ですか。

Cisco 200-301認定資格試験問題集 - 弊社の開発したソフトは非常に全面的です。

RoyalholidayclubbedのCiscoの200-301認定資格試験問題集試験トレーニング資料は豊富な経験を持っているIT専門家が研究したものです。君がCiscoの200-301認定資格試験問題集問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。もしCiscoの200-301認定資格試験問題集問題集は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。

今日、我々があなたに提供するCiscoの200-301認定資格試験問題集ソフトは多くの受験生に検査されました。彼らにCiscoの200-301認定資格試験問題集試験に合格させました。

200-301 PDF DEMO:

QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html

QUESTION NO: 2
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html

QUESTION NO: 3
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.

QUESTION NO: 4
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html

QUESTION NO: 5
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/

弊社のソフトを使用して、ほとんどのお客様は難しいと思われているCiscoのGenesys GCX-GCD試験に順調に剛角しました。 CiscoのCisco 300-710J試験に参加するのを決めるとき、あなたは強い心を持っているのを証明します。 American Society of Microbiology ABMM - 試験に失敗したら、全額で返金する承諾があります。 お客様か購入する前、我が社RoyalholidayclubbedのCBIC CIC問題集の見本を無料にダウンロードできます。 暇な時間だけでCiscoのOracle 1Z0-1123-25試験に合格したいのですか。

Updated: May 28, 2022

 

Copyright © 2006-2007

by RHC.

All rights reserved.
Revised: 21 Oct 2007

 

---------------

Google
 
Web www.RoyalHolidayClubbed.com

If you don't find what you are looking for here

to help you resolve your timeshare scam or Royal Holiday problem

please write to us at:

harpy @ royalholidayclubbed.com

Link Partner Directory

Privacy Policy

www . Royal Holiday Clubbed . com

Related Posts

 

sitemap