|
|
 |
200-301認定試験トレーリング & 200-301試験資料 - 200-301技術内容 - Royalholidayclubbed
|
|
RHC Destination Reviews
Who Is Harpy?
Need More Information?
もちろんありますよ。Royalholidayclubbedの問題集を利用することは正にその最良の方法です。Royalholidayclubbedはあなたが必要とするすべての200-301認定試験トレーリング参考資料を持っていますから、きっとあなたのニーズを満たすことができます。 Royalholidayclubbedがもっと早くCiscoの200-301認定試験トレーリング認証試験に合格させるサイトで、Ciscoの200-301認定試験トレーリング認証試験についての問題集が市場にどんどん湧いてきます。あなたがまだ専門知識と情報技術を証明しています強い人材で、RoyalholidayclubbedのCiscoの200-301認定試験トレーリング認定試験について最新の試験問題集が君にもっとも助けていますよ。 もしCiscoの200-301認定試験トレーリング問題集は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。
200-301認定試験トレーリング問題集を利用して試験に合格できます。
CCNA 200-301認定試験トレーリング - Cisco Certified Network Associate Exam Royalholidayclubbedはあなたが楽に試験に合格することを助けます。 Royalholidayclubbedは同業の中でそんなに良い地位を取るの原因は弊社のかなり正確な試験の練習問題と解答そえに迅速の更新で、このようにとても良い成績がとられています。そして、弊社が提供した問題集を安心で使用して、試験を安心で受けて、君のCisco 200-301 資格練習認証試験の１００％の合格率を保証しますす。
このような素晴らしい資料をぜひ見逃さないでください。IT技術の急速な発展につれて、IT認証試験の問題は常に変更されています。したがって、Royalholidayclubbedの200-301認定試験トレーリング問題集も絶えずに更新されています。
Cisco 200-301認定試験トレーリング - 近年、IT領域で競争がますます激しくなります。
Ciscoの200-301認定試験トレーリング試験に合格するのは早ければ速いほどIT業界で発展られたいあなたにとってはよいです。あなたはこの重要な試験を準備するのは時間とお金がかかると聞いたことがあるかもしれませんが、それは我々提供するCiscoの200-301認定試験トレーリングソフトを利用しなかったからです。複雑な整理と分析の過程はもう我々に完了されました。あなたは高効率の復習とCiscoの200-301認定試験トレーリング試験の成功を経験する必要があればいいです。
RoyalholidayclubbedのCiscoの200-301認定試験トレーリング試験トレーニング資料は豊富な知識と経験を持っているIT専門家に研究された成果で、正確度がとても高いです。Royalholidayclubbedに会ったら、最高のトレーニング資料を見つけました。
200-301 PDF DEMO:
QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 2
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 3
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 4
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
QUESTION NO: 5
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
Huawei H13-624_V5.5 - 数年間の発展で我々Royalholidayclubbedはもっと多くの資源と経験を得ています。 RoyalholidayclubbedのGIAC GRTP問題集の合格率が100%に達することも数え切れない受験生に証明された事実です。 大方の人は成功への近道がないとよく言われますけど、IT人材にとって、私達のHP HPE7-A08問題集はあなたの成功へショートカットです。 ABPMP CBPA - そうだったら、下記のものを読んでください。 弊社RoyalholidayclubbedのHuawei H19-483_V1.0試験問題集を介して、速く試験に合格してHuawei H19-483_V1.0試験資格認定書を受け入れる一方で、他の人が知らない知識を勉強して優れる人になることに近くなります。
Updated: May 28, 2022
|
Copyright © 2006-2007 by RHC.
All rights
reserved. |
---------------
If you don't find what you are looking for here
to help you resolve your timeshare scam or Royal Holiday problem
please write to us at:
harpy @ royalholidayclubbed.com
www . Royal Holiday Clubbed . com
|
|