|
|
 |
200-301勉強ガイド - 200-301試験復習赤本 & Cisco Certified Network Associate Exam - Royalholidayclubbed
|
|
RHC Destination Reviews
Who Is Harpy?
Need More Information?
あなたに成功に近づいて、夢の楽園に一歩一歩進めさせられます。Royalholidayclubbed Ciscoの200-301勉強ガイド試験トレーニング資料というのは一体なんでしょうか。Ciscoの200-301勉強ガイド試験トレーニングソースを提供するサイトがたくさんありますが、Royalholidayclubbedは最実用な資料を提供します。 当社の資料はあなたがIT専門家になるように特別に受験生の皆さんのために作成したものです。RoyalholidayclubbedのCiscoの200-301勉強ガイド試験トレーニング資料はあなたに最も適用して、あなたのニーズを満たす資料です。 試験の目標が変わる限り、あるいは我々の勉強資料が変わる限り、すぐに更新して差し上げます。
CCNA 200-301 Royalholidayclubbedを選んだら、成功への扉を開きます。
RoyalholidayclubbedのCiscoの200-301 - Cisco Certified Network Associate Exam勉強ガイド「Cisco Certified Network Associate Exam」試験問題集はあなたが成功へのショートカットを与えます。 したがって、Royalholidayclubbedの200-301 学習教材問題集も絶えずに更新されています。それに、Royalholidayclubbedの教材を購入すれば、Royalholidayclubbedは一年間の無料アップデート・サービスを提供してあげます。
このサイトはIT認定試験を受けた受験生から広く好評されました。これはあなたに本当のヘルプを与えるサイトです。では、なぜRoyalholidayclubbedは皆さんの信頼を得ることができますか。
Cisco 200-301勉強ガイド - 自分の幸せは自分で作るものだと思われます。
なぜみんなが順調にCiscoの200-301勉強ガイド試験に合格できることに対する好奇心がありますか。Ciscoの200-301勉強ガイド試験に合格したいんですか。実は、彼らが試験に合格したコツは我々Royalholidayclubbedの提供するCiscoの200-301勉強ガイド試験ソフトを利用したんです。豊富の問題集、専門的な研究と購入の後の一年間の無料更新、ソフトで復習して、自分の能力の高めを感じられます。Ciscoの200-301勉強ガイド試験に合格することができます。
あなたは弊社の高品質Cisco 200-301勉強ガイド試験資料を利用して、一回に試験に合格します。RoyalholidayclubbedのCisco 200-301勉強ガイド問題集は専門家たちが数年間で過去のデータから分析して作成されて、試験にカバーする範囲は広くて、受験生の皆様のお金と時間を節約します。
200-301 PDF DEMO:
QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 2
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 3
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 4
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
しかし、我々Royalholidayclubbedチームは力を尽くしてあなたのCiscoのMicrosoft SC-400J試験を準備する圧力を減少して規範的な模擬問題と理解しやすい解答分析はあなたにCiscoのMicrosoft SC-400J試験に合格するコツを把握させます。 Cisco Salesforce Advanced-Administrator-JPN試験認定書はIT職員野給料増加と仕事の昇進にとって、大切なものです。 Salesforce CRT-450 - これはあなたの能力を認めます。 多分、Huawei H29-111_V1.0テスト質問の数が伝統的な問題の数倍である。 Linux Foundation CKA - この時代にはIT資格認証を取得するは重要になります。
Updated: May 28, 2022
|
Copyright © 2006-2007 by RHC.
All rights
reserved. |
---------------
If you don't find what you are looking for here
to help you resolve your timeshare scam or Royal Holiday problem
please write to us at:
harpy @ royalholidayclubbed.com
www . Royal Holiday Clubbed . com
|
|